E-11EMitutoyo reserves the right to change any or all aspects of any product specication, including prices, designs and service content, without notice.• Dedicated gauge block sets for micrometer inspection. Sets 516-106/7/8 and 516-322/3 are recommended for checking instrumental errors in micrometers due to the choice of block sizes ensuring that the instrument is checked through a full rotation of the spindle over the range 0-25 mm (or 0-1 inch). Sets 516-115/6/7, 516-165/6 and 516-177 contain blocks in 25 mm (or 1 inch) steps for aiding inspection of large micrometers in conjunction with one of the abovementioned sets. Sets 516-580/1/2, 516-390/1/2 are dedicated to the QuantuMike with its 2 mm/rev spindle feed.Micrometer Inspection Gauge Block SetsSERIES 516SteelCERA(516-132/3/4/5/6/7)A set consisting of a Micro Checker and gauge blocks for micrometer inspection. Gauge Block Sets for Micrometer Inspection Steel 10-block setGauge BlocksLength Standards Brought to You by MitutoyoAn inspection certicate is supplied as standard. Refer to page E-4 for details.Steel 10-block setSteel 8-block setSteel 10-block setCERA 10-block setCERA 10-block setCERA 10-block setCERA 8-block setSPECIFICATIONSMetric Micro Checker (holder only)Order No.516-607Applicable gauge block sets516-106/107/108, 516-156/157/158Applicable gauge block sizes (mm)2.5, 5.1, 7.7, 10.3, 12.9, 15, 17.6, 20.2, 22.8, 25Inch Micro Checker (holder only)Order No.516-608Applicable gauge block sets516-921/922/923, 516-321/322/323Applicable gauge block sizes (inch)0.105, 0.210, 0.315, 0.420, 0.5, 0.605, 0.710, 0.815, 0.920, 1• Micro Checker516-607Usage example(The gauge block and optical parallel shown are optional accessories.)Can clamp a stack of gauge blocks to be used for micrometer inspection.