K-9KVision Measuring SystemsVision measuring systems for multipurpose useMitutoyo reserves the right to change any or all aspects of any product specication, including prices, designs and service content, without notice.Application exampleContour measurement of a ø0.125 mm holeMeasuring form of micro gear teeth UMAP Vision System TYPE2Micro Form Measuring SystemDetection of surface principle(1) In this drawing, the stylus is vibrating with micro amplitude. If it does not come into contact with the workpiece the vibration state is maintained.(2) As the stylus comes into contact with the workpiece surface the vibration amplitude decreases as the contact increases. When the decreasing amplitude falls below a certain level, a touch-trigger signal is generated.Ultrasonic Micro Probe UMAPContact measurement of a small hole's diameter, its section, or contour is possible, which is difcult with a conventional Vision Measuring System or CMM. Capable of high accuracy, sophisticated, non-contact and contact measurement on one machine. With a measuring force of 1 µN, measurement of a workpiece that is easily deformed or is very light.Detection signal after workpiece contactAmplitudeStylusWorkpieceDurationDetection signal before workpiece contactAmplitudeAmplitude reductionStylusWorkpieceDuration(1)(2)SPECIFICATIONS Model No.TYPE2Hyper UMAP302ULTRA UMAP404Measuring range (common to vision and UMAP)X axis × Y axis185×200 mm285×400 mmZ axisUMAP101/103175 mmUMAP107/110180 mmUMAP130185 mmMeasuring accuracy (Vision)E1X, E1Y(0.8+2L/1000) µm(0.25+L/1000) µmE1Z(1.5+2L/1000) µmRepeatabilityUMAP 101/103/107σ= 0.1 µmσ= 0.08 µmUMAP 110/130σ= 0.15 µmσ= 0.12 µmMicro probe, UMAP16 mmø300 µmø300 µmUMAP130 StylusNominal diameterø200 µmø100 µm10 mmø100 µmUMAP110 StylusNominal diameterø80 µmø70 µm9.5 mmUMAP107 Stylus5 mmø70 µmNominal diameterø53 µmUMAP101Stylusø15 µm0.2 mmø15 µmNominal diameterø9 µmUMAP103 Stylus2 mmø30 µmø30 µmNominal diameterø24 µm6.5 mmProducts equipped with the measurement data output function can be connected to the measurement data network system MeasurLink (refer to page A-5 for details).An inspection certicate is supplied as standard. Refer to page U-11 for details.Refer to UMAP Vision System Brochure (No. E14000) for more details.