N-19Coordinate Measuring MachinesPrecision measuring technology in three dimensionsMitutoyo reserves the right to change any or all aspects of any product specication, including prices, designs and service content, without notice.NRefer to the Probes for Coordinate Measuring Machines Brochure (No. E16005) for more details.Probe headsPH10M/10MQMotorized probe head The probe allows automatic control of positioning (up to 720 directions) of the mounted probe. It is possible to mount not only a touch-trigger probe but also any scanning probe, vision probe, laser probe, screw-thread depth probe, etc. Auto-changing is available (optional).sMounting example of touch-trigger probePH1MH20UMAP-CMMPH20Touch-trigger probe with manual probe head This touch-trigger probe equipped with a manual probe head is designed for use with manual CMMs. The probe head can be manually positioned to the desired orientation.Micro touch-trigger probeA stylus with an ultra-small diameter of 0.1 mm or 0.3 mm can be used.Measurement of miniscule form is possible by mounting on the PH10MQ.5-axis control touch-trigger system Thanks to unique "head touches", it is possible to measure by movement of the probe head itself instead of moving the CMM elements. Also, measuring time can significantly be shortened by means of 5-axis concurrent control and stepless positioning angle. MH20iTouch-trigger probe with manual probe head This touch-trigger probe equipped with a manual probe head is designed for use with manual CMMs. The probe head may be manually indexed to 168 positions. MIHManually indexable headThis probe head allows manual positioning (up to 720 directions) of the mounted probe (for TP200/TP20/TP2-5W). A probe extension of up to 300 mm in length can be attached. sMounting example of touch-trigger probeManual probe head This manual probe head is designed for use with the TP200/TP20 touch-trigger probes.The attached probe is manually positioned in the desired orientation to suit the measuring task. sMounting example of touch-trigger probeClamping System• A workpiece can be mounted on a CMMs measuring table using a variety of combinations of Eco-Fix clamping components. A dedicated xturing jig isn't necessary.• Economical starter kits "Eco-x Kit S" and "Eco-x Kit L" are available as shown below.A kit includes a 250 mm × 250 mm base plate and a variety of clamping components.A kit includes a 500 mm × 400 mm base plate and a variety of clamping components.Eco-fix Kit SEco-fix Kit LUsage examplePH6MFixed probe headA fixed probe head with autojoint connector for use with TP7M or SP25M.