MEASURING INSTRUMENTS CATALOG No.E2021
216/604

C-47CMitutoyo reserves the right to change any or all aspects of any product specication, including prices, designs and service content, without notice.• Used for quick and accurate setting of dial bore gages, Holtest, and inside micrometers.• Actual diameter is marked in 0.001 mm increments. (Dimension measuring position is the center of the height T.)Setting RingsSERIES 177 — Accessories for Inside Micrometers, Holtest and Dial Bore GagesBore GagesFor easy and accurate measurement of inside diametersHow to Read the Indicated Value• SERIES 526 The 526 Series contact points have high curvature. Alignment with the diameter (a-a') is achieved by rotating the gage head in the direction indicated by the arrow, and the reading is the maximum value read from the dial indicator.• SERIES 511The 511 Series provides a guide plate to align the setting ring diameter with the measurement axis of the bore gage. aa'Guide plateAnvilContact pointWorkpieceaa'Guide plateAnvilContact pointWorkpiece5図径ま値5簡のTøE25.4ødøDTødøDHKHK(H)(H) Side face(Marking face)Side faceSide face Side face(Marking face)Diameter calibrated at this positionMarkingMarkingType AType BDIMENSIONSUnit: mmSufx177-***-62:With Inspection Certicate (provides a record of the calibrated diameter) and Calibration Certicate177-***-82:With Inspection Certicate (provides a record of the calibrated diameter), Calibration Certicate, and Traceability System ChartNote 1: The Inspection Certicate is not a substitute for a calibration certicate as it is undated.Note 2: A more detailed inspection certicate describing roundness and cylindricity is available on request.Steel Setting RingsCERA Setting Rings177-146177-429177-432177-300Made-to-order• Custom-made setting rings Mitutoyo can manufacture setting rings to your size and design.• Nominal size range 1 mm to 305 mm (steel) 4 mm to 50 mm (ceramic)• Nominal size increment 0.01 mm (up to 45 mm) 0.02 mm (over 45 mm)

元のページ  ../index.html#216

このブックを見る