D-22DMitutoyo reserves the right to change any or all aspects of any product specication, including prices, designs and service content, without notice.Round jaws for accurate ID measurement• Long jaws for measuring hard-to-reach workpiece features.• Inside and outside measurements can be read directly from the upper and lower vernier scales.• Inside measurement is possible upwards from the minimum inside measuring length (jaws closed).Long Jaw Vernier CaliperSERIES 534 534-110SPECIFICATIONSMetric with inside measurement vernier scaleOrder No.Range (mm)*1Graduation (mm)Maximum permissible error (mm)*2RemarksEMPESMPE534-1090 (10.1) - 3000.05±0.07±0.07without ne adjustment534-1100 (20.1) - 500±0.13±0.13*1 ( ): Minimum dimension in ID measurement*2 Partial Surface Contact Error, EMPE and Shift Error, SMPE are terms (notations) used in ISO 13385-1:2019.Metric/Inch with metric/inch double scaleOrder No.Range (mm)*1GraduationMaximum permissible error (mm)*2RemarksEMPESMPE534-1010 (10.1) - 3000.05 mm/1/128 in±0.07±0.07+10 mm/0.394 in to reading in inside measurement without ne adjustment534-1050.02 mm/0.001 in±0.04±0.04534-1020 (20.1) - 5000.05 mm/1/128 in±0.13±0.13+20 mm/0.787 in to reading in inside measurement without ne adjustment534-1060.02 mm/0.001 in±0.06±0.06534-1030 (20.1) - 7500.05 mm/1/128 in±0.16±0.16534-1070.02 mm/0.001 in±0.08±0.08534-1040 (20.1) - 10000.05 mm/1/128 in±0.20±0.20534-1080.02 mm/0.001 in±0.10±0.10*1 ( ): Minimum dimension in ID measurement*2 Partial Surface Contact Error, EMPE and Shift Error, SMPE are terms (notations) used in ISO 13385-1:2019.Note: For external dimensions, refer to the series 534 on page D-23.
元のページ ../index.html#241