D-51DMitutoyo reserves the right to change any or all aspects of any product specication, including prices, designs and service content, without notice.• Enables efcient setting and inspection of calipers and height gages.CERA Caliper CheckerSERIES 515Outside measurementInside measurement515-555Outside measurementInside measurement515-556-2515-555205010015020030050150200250300INSIDE25010020mm05063539374.563535092050100150200300400500550600mm050100150250350450500550600INSIDE450200350300250400206846003003002502502002001501501001005050202055050045035025015010050201501002050CC-600C600550500450350250150100502020501001502003004005506005006006005505505005004504504004003503503003002502502002001501005020515-556-2Height GageA standard measuring tool of industryAn inspection certicate is supplied as standard. Refer to page U-9 for details.InchOrder No.Range (in)Block pitch accuracy*Parallelism of blocks*Mass (kg)1 - 12 in1 - 12 in515-5650 - 12±0.0002 in0.00008 in4* The block accuracy and the parallelism of blocks are based on the following:• Outside caliper and height gage: lower end reference plane • Inside caliper: inside reference planeSPECIFICATIONSMetricOrder No.Range (mm)Block pitch accuracy*Parallelism of blocks*Mass (kg)20 - 300 mm350 - 600 mm20 - 300 mm350 - 600 mm515-5550 - 300±5.0 µm—2.0 µm—4515-556-20 - 600±7.0 µm4.0 µm8.5* The block accuracy and the parallelism of blocks are based on the following:• Outside caliper and height gage: lower end reference plane • Inside caliper: inside reference planeDIMENSIONS Unit: mmOptional Accessories• 602162: Wooden case for 300 mm, 12 inch model• 602164: Wooden case for 600 mm model Typical applicationsChecking accuracy of caliper (inside measurement)Using plain jaws, a tie rod, knurled-head screws and square gauge blocks to construct a temporary caliper checker.Checking accuracy of height gageChecking accuracy of caliper (outside measurement)515-555Square Gauge Block Accessories SetRefer to page E-25 for details.• Be careful when using horizontally since the bottom face and measuring face are not precisely perpendicular to each other.
元のページ ../index.html#270