E-31EMitutoyo reserves the right to change any or all aspects of any product specication, including prices, designs and service content, without notice.• Measures the length of rectangular gauge blocks in the size range 0.5 mm to 100 mm. It automatically compares a test block with an appropriate reference gauge block. • The compensation result is not affected by any warping of thinner gauge blocks due to the use of upper and lower gage heads (dual-head system). • Measurement conguration: 1 cycle of automatic comparison measurement with a standard gauge block.Gauge Block Comparator GBCD-100A SERIES 565 — Automatic Comparator with Dual Gage Heads Special bridge-type blockGauge Block CalibrationLength Standards Brought to You by MitutoyoSPECIFICATIONSMetricRangeResolutionAccuracy in narrow range(20 °C)Upper gaging headTypeMeasuring forceContact point0.5 mm - 100 mm0.01 μm±(0.03 + 0.3L/1000) µm* L=Gauge block length (mm)Mu-Checker1 NCarbide contact point of radius 20 mmLower gaging headOperating conditionsTypeMeasuring forceContact pointMu-Checker0.6 NCarbide contact point of radius 5 mm20 °C±1 °C Humidity: 58% RH ±15% RH(Under less temperature change, and hot or cold direct air flow should be avoided.)* Uncertainty of measurement at the 95% condence level (not including the calibration error of the reference gauge block).516-145-E2An inspection certicate is supplied as standard. Refer to page U-9 for details.• Gauge block set for comparator calibration (optional) Standard type 516-145-E2
元のページ ../index.html#322