F-77FMitutoyo reserves the right to change any or all aspects of any product specication, including prices, designs and service content, without notice.Indicator CalibrationComparison measuring instruments which ensure high quality, high accuracy and reliability.i-Checker IC2000SERIES 170An inspection certicate is supplied as standard. Refer to page U-9 for details.Typical application for Dial Test Indicator Accessory SetIC2000Refer to the i-Checker Brochure (E12015) for more details.Small Tool Instrumentsand Data ManagementCatalog No. E12015(3)Inspection Instrument for Indicatorsi-CheckerE12015_3_I-Checker.indd 12020/07/15 17:56Typical application using dial test indicator attachment set (02ASK000)SPECIFICATIONSDIMENSIONSDial Test IndicatorsDigimatic IndicatorsLinear gagesLever gage headsBore GagesDial Indicators164ø200370.5189ø160559.57379.5384.8Stroke 100ø8 mm/ø9.525 mm (3/8 in), Standard accessoryOrder No.170-402170-403Remarkswith 8 mm bushwith 3/8 in bushMeasuring Range100 mmResolution0.01 μmAccuracy(20 °C)vertical orientation(0.1 + 0.4L/100) μm L=Arbitrary length (mm)lateral orientation(0.15 + 0.6L/100) μm L=Arbitrary length (mm)Feed speedMaximum 10 mm/sDrive methodMotor drive (semi-automatic/fully-automatic)Measuring UnitSeparate type Linear EncoderMeasurement methodSemi-automatic measurementFully automatic measurement (only when using an indicator equipped with data output function)*1*2Mass20 kgOperating temperature range20 °C±0.5 °C*1 Automatic measurement requires the indicator’s connecting cable. Additionally some form of indicator, along with the normally connected accessory (the optional accessory for the indicator such as a Digimatic power-supply unit in an EF counter) will be required. *2 The indicator measured via RS-232C has the capability to receive data from the main unit and output the counter value.• Indication accuracy of (0.1 + 0.4L/100) μm, the highest level in the world, is achieved. (When inspected in the vertical orientation.)• Can directly inspect indicators with a stroke of up to 100 mm. Moreover, a wide variety of optional accessories enable the inspection and calibration of many types of gage including dial indicators, lever-type dial indicators, dial test indicators, cylinder gages, Digimatic indicators, linear gages and electronic micrometers that use various stem diameters and support systems.• The pointer of the analog indicator is positioned just before the measuring point automatically in the semi-automatic mode.• Digital indicators equipped with a data output function are checked very efciently due to spindle positioning at the inspection points and recording of measurement results being under fully automatic control.

元のページ  ../index.html#418