K-9KVision Measuring SystemsVision measuring systems for multipurpose useMitutoyo reserves the right to change any or all aspects of any product specication, including prices, designs and service content, without notice.Typical applicationsContour measurement of a ø0.125 mm holeMeasuring form of micro gear teeth UMAP Vision System TYPE2Micro Form Measuring SystemDetection of surface principle(1) In this drawing, the stylus is vibrating with micro amplitude. If it does not come into contact with the workpiece the vibration state is maintained.(2) As the stylus comes into contact with the workpiece surface the vibration amplitude decreases as the contact increases. When the decreasing amplitude falls below a certain level, a touch-trigger signal is generated.Ultrasonic Micro Probe UMAPContact measurement of a small hole's diameter and its section or contour is possible, which is difcult with a conventional Vision Measuring System or CMM. Capable of high accuracy, sophisticated, non-contact and contact measurement on one machine. With a minimum measuring force of 1 µN, it is not only less likely to mark workpiece surfaces, but also enables measurement of workpieces that are highly susceptible to deformation.Detection signal after workpiece contactAmplitudeStylusWorkpieceDurationDetection signal before workpiece contactAmplitudeAmplitude reductionStylusWorkpieceDuration(1)(2)SPECIFICATIONS Model No.ItemsTYPE2Hyper UMAP 302ULTRA UMAP 404Measuring range (common to vision and UMAP)X axis×Y axis185×200 mm285×400 mmZ axisUMAP 101/103175 mmUMAP 107/110180 mmUMAP 130185 mmVision measuring accuracy E1X/E1Y(0.8 + 2L/1000) µm(0.25 + L/1000) µmE1Z(1.5 + 2L/1000) µmRepeatabilityUMAP 101/103/107σ=0.1 µmσ=0.08 µmUMAP 110/130σ=0.15 µmσ=0.12 µmMicro probe, UMAP16 mmø300 µmø300 µmUMAP 130 StylusNominal diameterø200 µmø100 µm10 mmø100 µmUMAP 110 StylusNominal diameterø80 µmø70 µm9.5 mmUMAP 107 Stylus5 mmø70 µmNominal diameterø53 µmUMAP 101Stylusø15 µm0.2 mmø15 µmNominal diameterø9 µmUMAP 103 Stylus2 mmø30 µmø30 µmNominal diameterø24 µm6.5 mmRefer to UMAP Vision System Brochure (E14000) for more details.Products equipped with the measurement data output function can be connected to the measurement data network system MeasurLink® (refer to page A-25 for details).An inspection certicate is supplied as standard. Refer to page U-9 for details.
元のページ ../index.html#520