N-13Coordinate Measuring MachinesPrecision measuring technology in three dimensionsMitutoyo reserves the right to change any or all aspects of any product specication, including prices, designs and service content, without notice.NManual Type CMMMICROCORD Crysta-Plus M Series Refer to the Crysta-Plus M Series Brochure (E16013) for more details.•Manual oating type CMMs developed in the quest for high accuracy, low cost and easy operation. •High-accuracy linear encoders (manufactured in-house) are built into the length measuring units used for position detection. Their excellent position detection capability is what makes the control of these high-accuracy devices possible. The series also applies a multitude of other technologies regarding structure, component processing, assembly, and other aspects that enable high-accuracy measurements.SPECIFICATIONSModel Items Crysta-Plus M443Crysta-Plus M544Crysta-Plus M574Measuring rangeX axis400 mm500 mmY axis400 mm400 mm700 mmZ axis300 mm400 mmAccuracy*E0, MPE3.0 + 4L/1000 µm3.5 + 4L/1000 µmPFTU, MPE4.0 µm4.0 µm* L = Measuring length (unit: mm)Note: While the appearance of the natural stone measuring table varies according to the source, the high stability for which this material is known can always be relied upon.•Clamping along the X, Y, or Z axes can be performed by pressing a button. Also, all models of the Crysta-Plus M Series support continuous ne feeding of clamped workpieces along the X, Y, or Z axes, over the entire range of measurement.•Equipped with a temperature compensation system that guarantees the specied accuracy within a wide range of temperature under certain environmental conditions, although CMMs should ideally be installed in a temperature controlled room. •Available options include the auto-leveling air-spring vibration isolator and the illuminator unit for the probe. Products equipped with the measurement data output function can be connected to the measurement data network system MeasurLink® (refer to page A-25 for details).Crysta-Plus M443Crysta-Plus M574

元のページ  ../index.html#580